Torsion Spring Replacement in Hollywood, FL
Torsion springs mount horizontally on a steel shaft directly above a closed garage door and twist — rather than stretch — to store lifting energy. They’re the standard system on most doors built or replaced since the 1990s.
Local context for Hollywood
The combination of heat and humidity typical around Hollywood is one of the more demanding climate profiles for garage door spring hardware in the continental US.
A torsion spring system consists of one or two springs wound tightly around a steel shaft that runs above the door opening, with cable drums at each end that spool the lift cables as the door rises. Instead of stretching like an extension spring, a torsion spring twists — winding tighter as the door closes and unwinding to release energy as the door opens. This design distributes weight evenly and is generally considered more durable and controllable than an extension-spring layout, which is why it’s become the standard on most doors manufactured in the last few decades.
Because the shaft and springs sit directly above the door opening, a torsion spring failure is unmistakable: a loud bang, a stuck or extremely heavy door, and sometimes a visible gap in the coil where the spring separated. Sizing a replacement torsion spring correctly requires the door’s exact weight along with the spring’s wire diameter, inside diameter, and length — get any of those wrong and the door will either strain the opener (spring too weak) or refuse to stay closed (spring too strong).
Torsion Spring Replacement problems we see in Hollywood
Accelerated cable fraying
Constant moisture exposure can wash away lubrication on lift cables faster than in drier climates, increasing fray-related wear near the spring drum.
Storm-related track and cable misalignment
Seasonal storms in humid climates can jar tracks and cables out of alignment, adding uneven load to torsion springs on older or unrated doors.
Door binds or feels uneven on a two-spring shaft
When only one of two torsion springs fails, the remaining spring still tries to lift the door, often causing binding or a crooked lift.
Rust or pitting along the spring coils
Corrosion weakens torsion spring steel from the surface inward and is a common trigger for failure in humid or coastal climates.
Frequently asked questions
Is broken garage door spring repair available in Hollywood?
Garage Door Spring Repair Co is expanding market by market across Florida. Submit a request through this page or call us directly to check current local availability in Hollywood.
Can one torsion spring be replaced without touching the other?
On a two-spring shaft, most technicians recommend replacing both at the same time even if only one failed, since they were installed together and are typically near the same point in their cycle life — replacing only one often leaves the door slightly unbalanced going forward.
What tools are required to replace a torsion spring safely?
Properly sized steel winding bars (not screwdrivers or other improvised tools), a secure ladder, and vise grips or clamps to secure the shaft are the minimum safety equipment. This is why torsion spring work is almost universally left to trained technicians.